(904) 605-5239
Southern Vintage Siding Jacksonville, Florida
Canned ham restoration

Canned Ham Trailer Siding

A canned ham trailer is a small vintage travel trailer named for its rounded shape. Our 3" Pattern, with narrow ribs 3 inches on center, was popular on trailers like these in the 1950s and 1960s.

3 inch pattern aluminum siding with narrow, closely spaced horizontal ribs in white enamel
3" Pattern, white enamel finish.
Pick up only

Jacksonville, Florida pick up only. At this time we do not ship siding. Pick up is one Saturday a month and we will coordinate a date with you.

Restoring the whole shell

Siding a canned ham trailer, section by section

Driver and passenger sides

The 3" Pattern gives smaller trailers a refined, authentic 1950s and 1960s look. Measure the length front to rear and the height at the tallest point.

Front and rear

Diamond Pattern was commonly used on vintage trailer fronts and rears. Measure the width at the widest point.

Roof

Roofing is continuous, one piece with two Pittsburgh seams. Measure front to rear over the top. It runs $38.00 a linear foot.

Good to know

Canned ham trailer questions

Which siding pattern is right for a canned ham trailer?

We recommend the 3 inch Pattern. Its narrow ribs suit smaller trailers, and it was popular on trailers from the 1950s and 1960s. Check the rib spacing on your own trailer before you order.

Does the same siding work on a teardrop trailer?

Yes. The 3 inch Pattern is also a good fit for teardrop trailers.

How much does it cost to side a canned ham trailer?

Siding is $26.00 a linear foot and roofing is $38.00 a linear foot. Enter your measurements on our order page and the estimate comes up on screen.

Know your measurements? Get your price in about ten seconds.

Siding runs $26.00 a linear foot — pattern and S-lock included, with no minimum order. Roofing is $38.00 a linear foot.