RV Aluminum Siding Panels for Vintage RVs
Replacing one damaged section or reskinning the whole rig, you order only what you need. Our RV aluminum siding comes off the roll former 49" wide by the length you choose, at $26.00 a linear foot with no minimum.
How to order replacement RV siding panels
Measure the section. For a side, take the length front to rear and the height at the tallest point. For the front or rear, take the width at the widest point.
Work out your panels. One panel covers about 4 feet of wall height, so a typical wall takes two panels. Multiply the panels by the length to get your linear feet.
Match your pattern. Measure your existing siding from the center of one rib to the center of the next. Our 3" and 6" patterns are measured the same way.
The order page has a measuring guide and a calculator that does this math for you.
RV siding questions
Can I replace just one section of RV siding?
Yes. There's no minimum order, so you can order the driver side, passenger side, front, rear or roof on its own.
Will your siding match the siding on my RV?
Compare the rib spacing and texture first. Our patterns are 3 inch ribs, 6 inch ribs, Diamond and Mesa. Measure your siding center to center, then look at the photos on our patterns page.
Do you make fiberglass RV siding?
No. We make aluminum siding and aluminum roofing only.
How long are the panels?
Panels are 49 inches wide and cut to the length you order, so the numbers you send are the numbers we roll.
Know your measurements? Get your price in about ten seconds.
Siding runs $26.00 a linear foot — pattern and S-lock included, with no minimum order. Roofing is $38.00 a linear foot.